May be you want to revise this once you inject properties that'll support HDMI output. PlatformInfo: there is absolutely no reason why you would use the SMBIOS of Haswell MacBookPro11.1 when you should be using SMBIOS of Ivy Bridge MacBookPro9,2 or MacBookPro10,2. I actually wonder where your ApfsDriverLoader module is coming from. Kernel: properly selects desired kexts and removes any contradictions mentioned aboveĭrivers: setup only selects those you want but I don't know if you should have ApfsDriverLoader.efi rather than HfsPlus.efi. Further properties are required if you want additional display ports, at least HDMI. Therefore no CPU power management.ĭevice Properties: injects correct properties for HiRes LCD but retains limitations to single display port (built-in LCD) only. Remove the latter it's either USBPorts or USBInjectAll+SSDT-UIAC (which you don't have).ĭoes not call for the CPU PM SSDT that's in the ACPI folder. Remove the latter 2, they've been kind of obsolete for some time now. You only need to use and declare those drivers you need: Audio (if you want startup chime), OpenRunTime, HfsPlus and, if you use the OC GUI, OpenCanopy.ĪirPortBrcmFixup vs. SSDT-PM is for a quad-core i7-3740QM, I assume this is the CPU you have, therefore correct CPU PM SSDT if not, you know the drill. SSDT-EC-USBX which is for newer systems (Skylake and later) and therefore irrelevant for you. SSDT-EC which is Ok for older systems (up to Broadwell) such as your Ivy Bridge E6430. On the other hand, the OC EFI you posted contains many incorrect items. ![]() You know, kexts are the same whether you boot with Clover or OpenCore and the same goes for caching kexts from /L/E. I can assure you that there is nothing in the kexts folder of the packs I posted that could be specifically for Clover. Meantime and/or in the interim, you may just boot with boot argĪdded to the NVRAM section. ![]() JakeLo posted the necessary stuff in several E6x20/E6x30 NVS x200M threads. You may use these E6430 HD4000-only packs for your OpenCore setup just copy the files and folders of the packs to the OC folder of your EFI partition/folder and replace any existing stuff.įor an E6430 with nVidia graphics, enable Optimus in BIOS but disable the dGPU through DSDT/SSDT patching. You may also refer to my E6230 guide for general guidance though I've left out some properties injection out of the OpenCore config given that they were already in the patched DSDT (ECDV->EC, EHCx->EH0x, IGPU properties, etc.). The issue at hand must be something post a zipped copy of your EFI folder so that we check it out. I have repeatedly been able to install Big Sur on my E6230 with SMBIOS of unsupported MacBookPro9,2 and MacBookPro10,2 with -no_compat_check boot arg.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |